LiviPod LED Light Colors and Definitions

LiviPod LED Light Colors and Definitions

Applies to: all LiviPod™ Pods running the latest LiviPod firmware

Each Pod has a small light that changes color to show what it's doing. Most of the time the light is off. That's normal and means your Pod is ready.


Light colors at a glance

What you seeWhat it meansWhat to do
○ No lightYour Pod is on and ready.Nothing. This is normal.
● Orange, then blue (after plugging in)Your Pod is starting up.Nothing. The light turns off after a few seconds when it's ready.
● Light blue, a short flash every few secondsA dose from this Pod is ready to take.Take your dose in the LiviPod App. The flashing stops after you take or skip it.
● Yellow, flashing on and offYou tapped this Pod in My Pods, so it's showing you which one it is.Nothing. It stops on its own.
● Yellow, steadyYour Pod is dispensing and counting pills.Wait for it to finish.
● Green, steadyYour dose was dispensed successfully.Nothing. The light turns off after about a minute.
● Red, steady (after dispensing)Your Pod couldn't count a pill, or something is blocking the pill path.Follow the message in the LiviPod App. See below.
● Red, steady (after plugging in) that never changesYour Pod couldn't start.Unplug it for 10 seconds, then plug it back in.

The startup light: orange, then blue

Every time your Pod gets power, it goes through a short startup. That happens when you plug it in, when the power comes back after an outage, and when it restarts after a firmware update.

  1. Orange for about 5 seconds. Your Pod is starting up.
  2. Blue for about 2 seconds. Your Pod is turning on Bluetooth so it can talk to the LiviPod App.
  3. The light turns off. Your Pod is ready.

The whole startup takes less than 10 seconds. Your Pod may take a little longer to show as online in My Pods while it reconnects to Wi-Fi, but the light doesn't change for that.

If the light turns red during startup and stays red, your Pod couldn't start. Unplug it for 10 seconds, then plug it back in. If it's still red, contact LiviPod support.


The dose light: light blue

When a dose is due, the Pod holding that medication gives a short light-blue flash every few seconds. It's a gentle reminder, so you can see at a glance which Pod your next dose comes from.

The flashing stops when:

  • you take the dose, or
  • you skip the dose, or
  • the dose window ends (up to 2 hours after the dose time).

If you have several Pods, only the ones with a dose ready will flash.

Not seeing the dose light? It needs the latest LiviPod firmware and the latest LiviPod App. Open the LiviPod App and update both. Pods on older LiviPod firmware still dispense normally, they just don't flash when a dose is ready.


Red after dispensing

A steady red light after a dispense means your Pod stopped because it couldn't confirm a pill came out. The LiviPod App will show one of these messages:

  • "Medication not detected. Please confirm there is inventory". The Pod may be empty, or the pills may not be dropping. Check that it has medication in it, then follow the steps in the app to try again or skip.
  • "A jam has been detected. Please remove the drawer and clear the pill path." Something is blocking the pill path. Remove the drawer, clear anything stuck, put the drawer back, then follow the steps in the app.

If you don't respond in the app, the red light clears itself after about 3 minutes and the Pod is ready for your next dose.


Things the light does not show

  • Wi-Fi. The light doesn't change when your Pod connects to or loses Wi-Fi. To check whether a Pod is online, look at My Pods in the LiviPod App.
  • Low medication. The light doesn't warn you when a Pod is running low. The LiviPod App keeps track of your pill count.

Still not sure?

  • The light is blinking light blue but no dose is due, or it keeps flashing after you've taken your dose: unplug the Pod for 10 seconds, then plug it back in.
  • The light stays red after you unplug it and plug it back in: contact LiviPod support.

When you contact support, please tell us:

  • which color you see
  • whether it's steady or flashing
  • what you were doing just before it happened (plugging in, dispensing, or nothing)